This study shows the comparative analysis engineering, the physical and mechanical properties of river sand concrete with quarry dust concrete. The selected materials were batched by weight and volume. The water-cement ratio was opted as 0.50 1:2:4 for mix ratio was selected for the experimental investigation, respectively. The specimens were cured …

In this study, the concrete will be made by partially replacing cement with fly-ash, FA with quarry dust, CA with CS. Concrete cylinder and cubes will be casted and test will be conducted for ...

Therefore, water to cement ratio was increased for concrete with quarry dust to sustain similar workability of conventional concrete [31,32]. On the other hand, the presence of quarry dust improved the mechanical characteristics and durability aspects of the concrete [29,33]. ... Journal of Hazardous Materials, Volume 381, 2020, Article …

The quarry dust is use in the concrete and the properties are studied experimentally and presented in this paper. Concrete is prepared with the process of …

quarry dust in concrete, ... Recycling demolition waste sandcrete blocks as aggregate in concrete, ARPN Journal of Engineering and . Applied Sciences, 2012, Vol. 7, 1111-18.

Journal of Engineering Research and Reports. 23 (1): 10-21, ... ISSN: 2582-2926. The Strength Characteristics of Concrete Blended . with Recycled Concrete, Quarry Dust and . Broken Glass .

There are many studies on the effects of quarry dust, such as marble dust, granite dust, crushed rock dust, and limestone powder, on the bleeding and segregation of cement-based composites [77,78,79,80,81]. In all the studies examined, it was emphasized that the use of non-pozzolanic fillers in mortar or concrete mixtures increased bleeding …

This paper presents the results of an experimental investigation carried out to evaluate the compressive strength and transverse strength of 1 : 3 mortar mixes in which natural sand was replaced with 20%, 50%, and quarry dust by weight which were further modified by partially replacing cement with four percentages (15%, …

The aim is to provide a snapshot of some of the most exciting work published in the various research areas of the journal. ... P.B.; Waghe, U.P. Effect of characterization properties on compressive strength of concrete containing quarry dust and waste plastic as fine aggregate. Int. J. Civ. Eng. Tech. (IJCIET) 2017, 8, 699–707. [Google Scholar]

AbstractThis study compared the physical and mechanical properties of river sand concrete with quarry dust concrete. The constituent materials were batched by weight. The water-cement ratio and mix ratio selected for the experimental investigation were 0.55 and 1:2:4, respectively. The specimens were cured for 7, 14, 21 and 28 days. …

Curing is done strictly as per the Concrete with quarry dust as fine aggregate In a specification of IS 156 : 1959, curing is done at the study in Thailand by Khamput [11] on the compressive room temperature in curing tank filled with normal strength of concrete using quarry dust as fine aggregate and clean water. mixing with admixture type E ...

G. Balamurugan, Dr. P. Perumal, et al ( Nov, 2013) This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to in steps of 10%. M20 and M25 grades of concrete are taken for the study keeping a constant slump of 60mm.

Results from this study concludes that increase in quantity of dust up to 30% increases compressive strength of concrete, if the %age of quarry dust is more than 30% thee compressive strength starts decreasing gradually. (Dr. P.B.Sakthivel -2013) This papers deals with the replacement of natural sand used in concrete with quarry dust …

Cited by (27) Journal of Building Engineering Volume 35, March 2021, 102092 Effects of different industrial waste materials as partial replacement of fine aggregate on …

Title: Investigating Strength Properties of Geopolymer Concrete with Quarry Dust Author(s): A. Muthadhi and V. Dhivya Publication: Materials Journal Volume: 114 Issue: 3 Appears on pages(s): 355-363 Keywords: Class C fly ash; compressive strength; geopolymer concrete; quarry dust DOI: 10.14359/51689674 Date: 5/1/2017 Abstract: To …

In this study, an attempt has been made to find the suitability of quarry dust and foundry sand as fine aggregate. To test the hardened properties of concrete by …

grades of concrete by replacement of sand with quarry dust. Key Words: Concrete, Compressive strength, Quarry Dust, Replacement, Sand. 1. INTRODUCTION Quarry dust, is a by-product releases from the cutting and crushing process of stone which is a concentrated material to use as fine aggregates. By exploding mountain, rock will be …

One such material is Quarry stone dust: a by-product obtained during quarrying process. Attempts have been made to study the suitability of Quarry dust as sand replacing …

The objective of this work is to study the strength and corrosion resistive properties of concrete containing quarry dust as fine …

Durability of Quarry Rock Dust concrete under sulphate and Mix proportions were arrived at for M60 grade of HPC trial acid action is higher inferior to the Conventional Concrete mix based on the above formulated mix design procedure Permeability Test results clearly demonstrates that by adding 15% of the mass of cement with silica fume at a ...

This quarry dust is produced in large quantities by the stone dressers who create Kashmiri hamams (rooms with hollow bottoms where firewood is burned to produce heat) and other stoneware artifacts. ... Mix design development of fly ash-GGBS based recycled aggregate geopolymer concrete, Journal of Building Engineering, Volume 63, …

The 20mm with specific gravity of 2.67. replacement of sand as a major ingredient of concrete by quarry dust will be a techno economic solution to the above problem .The present research work was carried out to study D. Quarry dust the strength and stability of concrete containing quarry dust Quarry dust a by-product of stone crushing has been ...

R.Ilangovana,N.Mahendran [2], aims at the strength and durability properties of concrete containing quarry rock dust as fineaggregate .this study presents the feasibility of usage of quarry rock dust as substitute for natural sand in concrete mixdesign developed for three grades M- 20,M-30,M-40 using an design approach …

International Journal of Engineering Research & Technology (IJERT) ISSN: 2278-0181 Vol. 4 Issue 06, June-2015 Behaviour of Concrete Subjected to Elevated Temperature by Replacing of Fine Aggregate with GBFS and Quarry Dust Nagadorai A Dr Y M Manjunath P G student Professor of Civil Engineering Department of Civil Engg National Insitution of ...

Concrete mechanical properties could be improved through adding different materials at the mixing stage. Quarry dust (QD) is the waste produced by manufactured sand machines and comprise …

The use of up to 22.5 percent quarry dust as fine aggregate in EPS- concrete [37,38] resulted in a 30 percent increase in compressive strength [39,40]. In addition, quarry dust and copper slag are used in current research to replace river sand. Concrete containing 40% copper slag have a higher compressive strength than …

Compressive strength of M30 with 20%, 25% and 30% replacement for 3, 7 and 28 days The slight variation is observed in compressive strength for 3 days and 7 days age in concrete.

We are investigating the potential of using quarry waste and its effect on the strength and workability of concrete. This paper reports the experimental study which investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25).

The maximum temperature differential in a conventional concrete slab is 12.10C, 11.60C in a quarry dust concrete slab, and 11.10C in an M−sand concrete slab. ... "Replacement of Recycled Construction and Demolition Waste Coarse Aggregates in Pavement Quality Concrete", International Journal of Applied Engineering Research, …